No ACL setup yet! Denying access to everyone.
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
projects:mees [2021/03/22 09:36] – [Used parts:] trimen | projects:mees [2021/04/06 16:05] – [TODO for REV. B] trimen | ||
---|---|---|---|
Line 15: | Line 15: | ||
SI7021 - relative humidity and temperature sensor\\ | SI7021 - relative humidity and temperature sensor\\ | ||
< | < | ||
- | M24M01-RMN6P - I2C EEPROM for calibration data storage\\ | + | M24M01-RMN6P - I2C EEPROM for calibration data storage\\ |
ESP8285 - main CPU with WiFi\\ | ESP8285 - main CPU with WiFi\\ | ||
Line 27: | Line 27: | ||
===TODO for REV. B=== | ===TODO for REV. B=== | ||
Add pull-up resistor to GPIO2\\ | Add pull-up resistor to GPIO2\\ | ||
- | Add clearance on sides of antenna\\ | + | Add clearance on sides of antenna/use chip antenna\\ |
Find another USB to UART converter, because Silicon Labs chips are unavailable\\ | Find another USB to UART converter, because Silicon Labs chips are unavailable\\ | ||
+ | Find another temperature and humidity sensor\\ | ||
+ | Enlarge board & add better thermal isolation between CPU, gas sensors, and temperature sensor\\ | ||
+ | --> currently this isn't an issue when the fan is unregulated\\ | ||
+ | Add mounting holes\\ | ||
+ | Add 4R7+1uF RC element to VDD of SGP40 and CCS811 sensor\\ | ||
+ | Add UART on board for particle sensors (HPMA115C0-XXX, | ||
+ | Add RF blocking inductor to VDDPA of ESP8285\\ | ||
+ | Add RGB LED for indication\\ | ||
+ | |||
+ | |||