No ACL setup yet! Denying access to everyone.

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
projects:mees [2021/03/25 17:37] – [TODO for REV. B] trimenprojects:mees [2022/01/11 20:07] (current) – [Used parts:] trimen
Line 14: Line 14:
 CSS811 - TVOC and eCO2 sensor\\ CSS811 - TVOC and eCO2 sensor\\
 SI7021 - relative humidity and temperature sensor\\ SI7021 - relative humidity and temperature sensor\\
-<del>MR44V100AMAZAATL - I2C FRAM for data logging</del> +<del>MR44V100AMAZAATL - I2C FRAM for data logging</del> \\
  M24M01-RMN6P - I2C EEPROM for calibration data storage\\  M24M01-RMN6P - I2C EEPROM for calibration data storage\\
 ESP8285 - main CPU with WiFi\\ ESP8285 - main CPU with WiFi\\
Line 28: Line 28:
 Add pull-up resistor to GPIO2\\ Add pull-up resistor to GPIO2\\
 Add clearance on sides of antenna/use chip antenna\\ Add clearance on sides of antenna/use chip antenna\\
-Find another USB to UART converter, because Silicon Labs chips are unavailable\\+Find another <del>USB to UART converter</del> chips, because <del>Silicon Labs</del> chips are unavailable\\
 Find another temperature and humidity sensor\\ Find another temperature and humidity sensor\\
 Enlarge board & add better thermal isolation between CPU, gas sensors, and temperature sensor\\ Enlarge board & add better thermal isolation between CPU, gas sensors, and temperature sensor\\
 + -> maybe a mezzanine board?\\
 --> currently this isn't an issue when the fan is unregulated\\ --> currently this isn't an issue when the fan is unregulated\\
 Add mounting holes\\ Add mounting holes\\
Line 36: Line 37:
 Add UART on board for particle sensors (HPMA115C0-XXX, SPS30...)\\ Add UART on board for particle sensors (HPMA115C0-XXX, SPS30...)\\
 Add RF blocking inductor to VDDPA of ESP8285\\ Add RF blocking inductor to VDDPA of ESP8285\\
 +Add RGB LED for indication\\