Differences

This shows you the differences between two versions of the page.

--- projects:mees [2021/01/19 17:29] – [Used parts:] trimen
+++ projects:mees [2022/01/11 20:07] (current) – [Used parts:] trimen
@@ Line 1: / Line 1: @@
 =======MEES=======
 (MQTT enabled environmental sensor)
+{{:projects:single.jpg?400|}}
 =====About=====
@@ Line 13: / Line 14: @@
 CSS811 - TVOC and eCO2 sensor\\
 SI7021 - relative humidity and temperature sensor\\
-MR44V100AMAZAATL - I2C FRAM for data logging\\
+<del>MR44V100AMAZAATL - I2C FRAM for data logging</del> \\
+ M24M01-RMN6P - I2C EEPROM for calibration data storage\\
 ESP8285 - main CPU with WiFi\\
@@ Line 19: / Line 21: @@
 Desing board - DONE\\
 Order board - DONE\\
-Assembly and test\\
+Assembly and test - DONE\\
 Develop SW\\
 Integrate with ventilation\\
+===TODO for REV. B===
+Add pull-up resistor to GPIO2\\
+Add clearance on sides of antenna/use chip antenna\\
+Find another <del>USB to UART converter</del> chips, because <del>Silicon Labs</del> chips are unavailable\\
+Find another temperature and humidity sensor\\
+Enlarge board & add better thermal isolation between CPU, gas sensors, and temperature sensor\\
+ -> maybe a mezzanine board?\\
+--> currently this isn't an issue when the fan is unregulated\\
+Add mounting holes\\
+Add 4R7+1uF RC element to VDD of SGP40 and CCS811 sensor\\
+Add UART on board for particle sensors (HPMA115C0-XXX, SPS30...)\\
+Add RF blocking inductor to VDDPA of ESP8285\\
+Add RGB LED for indication\\