No ACL setup yet! Denying access to everyone.

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Next revisionBoth sides next revision
projects:mees [2021/03/25 17:30] – [Used parts:] trimenprojects:mees [2022/01/11 19:50] – [TODO for REV. B] trimen
Line 28: Line 28:
 Add pull-up resistor to GPIO2\\ Add pull-up resistor to GPIO2\\
 Add clearance on sides of antenna/use chip antenna\\ Add clearance on sides of antenna/use chip antenna\\
-Find another USB to UART converter, because Silicon Labs chips are unavailable\\+Find another <del>USB to UART converter</del> chips, because <del>Silicon Labs</del> chips are unavailable\\
 Find another temperature and humidity sensor\\ Find another temperature and humidity sensor\\
 Enlarge board & add better thermal isolation between CPU, gas sensors, and temperature sensor\\ Enlarge board & add better thermal isolation between CPU, gas sensors, and temperature sensor\\
 +--> currently this isn't an issue when the fan is unregulated\\
 Add mounting holes\\ Add mounting holes\\
 +Add 4R7+1uF RC element to VDD of SGP40 and CCS811 sensor\\
 +Add UART on board for particle sensors (HPMA115C0-XXX, SPS30...)\\
 +Add RF blocking inductor to VDDPA of ESP8285\\
 +Add RGB LED for indication\\
 +