No ACL setup yet! Denying access to everyone.

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Last revisionBoth sides next revision
projects:mees [2021/01/19 17:29] – [Used parts:] trimenprojects:mees [2022/01/11 20:06] – [TODO for REV. B] trimen
Line 1: Line 1:
 =======MEES======= =======MEES=======
 (MQTT enabled environmental sensor) (MQTT enabled environmental sensor)
 +{{:projects:single.jpg?400|}}
 =====About===== =====About=====
  
Line 13: Line 14:
 CSS811 - TVOC and eCO2 sensor\\ CSS811 - TVOC and eCO2 sensor\\
 SI7021 - relative humidity and temperature sensor\\ SI7021 - relative humidity and temperature sensor\\
-MR44V100AMAZAATL - I2C FRAM for data logging\\+<del>MR44V100AMAZAATL - I2C FRAM for data logging</del>  
 + M24M01-RMN6P - I2C EEPROM for calibration data storage\\
 ESP8285 - main CPU with WiFi\\ ESP8285 - main CPU with WiFi\\
  
Line 19: Line 21:
 Desing board - DONE\\ Desing board - DONE\\
 Order board - DONE\\ Order board - DONE\\
-Assembly and test\\+Assembly and test - DONE\\
 Develop SW\\ Develop SW\\
 Integrate with ventilation\\ Integrate with ventilation\\
 +
 +===TODO for REV. B===
 +Add pull-up resistor to GPIO2\\
 +Add clearance on sides of antenna/use chip antenna\\
 +Find another <del>USB to UART converter</del> chips, because <del>Silicon Labs</del> chips are unavailable\\
 +Find another temperature and humidity sensor\\
 +Enlarge board & add better thermal isolation between CPU, gas sensors, and temperature sensor\\
 + -> maybe a mezzanine board?\\
 +--> currently this isn't an issue when the fan is unregulated\\
 +Add mounting holes\\
 +Add 4R7+1uF RC element to VDD of SGP40 and CCS811 sensor\\
 +Add UART on board for particle sensors (HPMA115C0-XXX, SPS30...)\\
 +Add RF blocking inductor to VDDPA of ESP8285\\
 +Add RGB LED for indication\\
 +
 +
 +